Your cart is empty
This tool makes AR hammer/trigger pin removal and installation a snap! Use the steel pin to push the hammer and trigger pins out of the receiver. The forked end is then used to easily manage the springs while installing the hammer and hammer pin.
NOTE: The steel pin's polished and rounded end is not intended to be hammered. The polymer tool is used as a handle to positively contact and press out the hammer and trigger pins without damage to any finishes.
The tool's hammer spring holes are reinforced with steel set screws, which prevents against long-term wear on the polymer. The polymer is carbon fiber reinforced high-temperature nylon.
This design featuring engineering-grade material, set screws and the steel push pin sets this tool WAY above those available on eBay.
Offered in conjunction with Ned at Michiguns, which is linked HERE.
Video of the this tool can be seen HERE. If you don't understand the utility of this device, the video WILL change your mind!
To our knowledge, this should work with any AR trigger, including Geissele, LaRue, Mil-Spec, etc.